Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)

STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE LOWER STEERING COLUMN COVER


C181134
  1. Remove the 2 screws.

  1. Detach the 2 claws to remove the lower steering column cover.



2. REMOVE UPPER STEERING COLUMN COVER


    C159215
  1. Detach the 4 clips.

  1. Detach the claw to remove the upper steering column cover.



3. INSPECT TILT MOTOR


C106479E12
  1. Apply the 12 V battery voltage to the tilt motor connector. Then check the steering wheel tilt operation.

    OK:
    Measurement Condition
    Specified Condition
    12 V battery positive (+) lead → Terminal 2 (TIM+)
    12 V battery negative (-) lead → Terminal 1 (TIM-)
    The steering wheel tilts up.
    12 V battery positive (+) lead → Terminal 1 (TIM-)
    12 V battery negative (-) lead → Terminal 2 (TIM+)
    The steering wheel tilts down.



4. INSPECT TELESCOPIC MOTOR


C149086E03
  1. Disconnect connector A from the multiplex tilt and telescopic ECU.

  1. Apply 12 V battery voltage to the multiplex tilt and telescopic ECU connector. Then check the steering wheel telescopic operation.

    OK:
    Measurement Condition
    Specified Condition
    12 V battery positive (+) lead → Terminal A-2 (TEM+)
    12 V battery negative (-) lead → Terminal A-6 (TEM-)
    The steering column contracts.
    12 V battery positive (+) lead → Terminal A-6 (TEM-)
    12 V battery negative (-) lead → Terminal A-2 (TEM+)
    The steering column extends.



5. INSTALL UPPER STEERING COLUMN COVER


C159215
  1. Attach the claw to install the upper steering column cover.

  1. Attach the 4 clips.



6. INSTALL LOWER STEERING COLUMN COVER


C181134
  1. Attach the 2 claws to install the lower steering column cover.

  1. Install the 2 screws.