Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › MASS AIR FLOW METER

MASS AIR FLOW METER > INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER


    A165595E02
  1. Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

    OK:
    There is no foreign material.

    If the result is not as specified, replace the mass air flow meter.



  1. Check the IAT sensor.


    A187057E02


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (THA) - 5 (E2)
      -20°C (-4°F)
      12.5 k to 16.9 kΩ
      20°C (68°F)
      2.19 k to 2.67 kΩ
      60°C (140°F)
      0.50 k to 0.68 kΩ

      If the result is not as specified, replace the MAF meter.