Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › ACCELERATOR PEDAL

ACCELERATOR PEDAL > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
  1. Avoid physical shocks to the accelerator pedal sensor assembly.
  2. Do not disassemble the accelerator pedal sensor assembly.
  3. This accelerator pedal does not require lubrication.
    Do not apply oil or other lubrication to the accelerator pedal sensor assembly.
    If applied, the accelerator pedal sensor assembly must be replaced.



    A153493
  1. Install the accelerator pedal sensor assembly with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the accelerator pedal sensor connector.