AIR FUEL RATIO SENSOR > INSTALLATION |
| 1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Install the air fuel ratio sensor to the front No. 2 exhaust pipe assembly by hand.
![]() |
Using SST, tighten the air fuel ratio sensor.
| 2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Install the air fuel ratio sensor to the front exhaust pipe assembly by hand.
![]() |
Using SST, tighten the air fuel ratio sensor.
| 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Install a new gasket and the front exhaust pipe assembly to the exhaust manifold RH with 3 new nuts.
Install a new gasket and the front exhaust pipe assembly to the center exhaust pipe assembly with the 2 bolts.
Connect the air fuel ratio sensor connector.
Connect the heated oxygen sensor connector and attach the 2 clamps.
| 4. INSTALL FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY |
![]() |
Install a new gasket and the front No. 2 exhaust pipe sub-assembly to the exhaust manifold LH with 3 new nuts.
Install a new gasket and the front No. 2 exhaust pipe sub-assembly to the front No. 3 exhaust pipe sub-assembly with the 2 bolts and 2 new nuts.
Connect the air fuel ratio sensor connector.
Connect the heated oxygen sensor connector and 2 clamps.
| 5. INSPECT FOR EXHAUST GAS LEAK |