ECM > INSTALLATION |
| 1. INSTALL GASKET |
Clean the ECM seal's surface with non-residue solvent.
Attach a new gasket to the ECM.
| 2. INSTALL ECM |
![]() |
Install the ECM with the 4 bolts.
![]() |
Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.
| 3. CONNECT CONNECTOR HOLDER BLOCK |
![]() |
Connect the connector holder block with the 3 bolts.
| 4. INSTALL AIR CLEANER ASSEMBLY |
![]() |
Attach grommet to air cleaner before mounting the air cleaner.
Insert the air cleaner into the fender apron hole, and fully insert pin to grommet.
![]() |
Install the air cleaner with the 2 bolts.
Connect the connector and install the clamp and wire harness.
Connect the air cleaner hose and tighten the clamp.
| 5. PERFORM INITIALIZATION |
Perform initialization procedures (Click here).