Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY

REAR NO. 1 SEAT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.



1. INSTALL REAR NO. 1 SEAT ASSEMBLY RH
  1. Place the rear No. 1 seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.



    B191135
  1. Insert the 2 locating pins through the 2 body holes, move the rear No. 1 seat to its rearmost position, and make sure that the inner and outer seat tracks are locked securely.

  1. Install the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    B191080
  1. Lift up the seat track adjusting handle to move the seat to the foremost position and make sure that the inner and outer seat tracks are locked securely.

  1. Install the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



2. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (w/ Seat Heater System)
  1. Place the rear No. 1 seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.



    B191135
  1. Insert the 2 locating pins through the 2 body holes, move the rear No. 1 seat to its rearmost position, and make sure that the inner and outer seat tracks are locked securely.

  1. Install the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    B191080
  1. Lift up the seat track adjusting handle to move the seat to the foremost position and make sure that the inner and outer seat tracks are locked securely.

  1. Install the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    B191078
  1. Attach the wire harness clamp and connect the seat heater connector.



3. INSTALL SEAT TRACK BRACKET COVER INNER (w/ Center Seat)


    B191076
  1. Attach the 9 clips to install the seat track bracket cover.



4. INSTALL SEAT TRACK BRACKET COVER INNER


    B191077
  1. Attach the 6 clips to install the seat track bracket cover.

  1. Lift up the seat track adjusting handle to move the seat to the rearmost position.



5. INSTALL REAR SEAT TRACK BRACKET COVER INNER


    B195211
  1. Attach the 2 claws to install the rear seat track bracket cover.



6. INSTALL REAR SEAT TRACK BRACKET COVER OUTER


    B191075
  1. Attach the 2 claws to install the rear seat track bracket cover.



7. INSTALL REAR DOOR SCUFF PLATE RH


    B186666
  1. Attach the 2 claws and 5 clips to install the rear door scuff plate.

  1. Install the 2 bolts.



    B186665
  1. Attach the 6 claws, 5 clips and 2 guides to install the rear door scuff plate.

  1. Install the screw.



8. INSTALL REAR FLOOR STEP NO. 1 COVER


    B191404
  1. Attach the 2 claws to install the rear floor step No. 1 cover.



9. INSTALL REAR FLOOR STEP NO. 2 COVER


    B193890
  1. Attach the 2 claws to the install the rear floor step No. 2 cover.



10. INSTALL REAR SEAT CUSHION HINGE COVER LOWER RH


    B191794
  1. Attach the 2 clips and 5 claws to install the rear cushion hinge lower cover RH.