REAR NO. 1 SEAT ASSEMBLY > INSTALLATION |
| 1. INSTALL REAR NO. 1 SEAT ASSEMBLY RH |
Place the rear No. 1 seat assembly in the cabin.
![]() |
Insert the 2 locating pins through the 2 body holes, move the rear No. 1 seat to its rearmost position, and make sure that the inner and outer seat tracks are locked securely.
Install the 2 bolts.
![]() |
Lift up the seat track adjusting handle to move the seat to the foremost position and make sure that the inner and outer seat tracks are locked securely.
Install the 2 bolts.
| 2. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (w/ Seat Heater System) |
Place the rear No. 1 seat assembly in the cabin.
![]() |
Insert the 2 locating pins through the 2 body holes, move the rear No. 1 seat to its rearmost position, and make sure that the inner and outer seat tracks are locked securely.
Install the 2 bolts.
![]() |
Lift up the seat track adjusting handle to move the seat to the foremost position and make sure that the inner and outer seat tracks are locked securely.
Install the 2 bolts.
![]() |
Attach the wire harness clamp and connect the seat heater connector.
| 3. INSTALL SEAT TRACK BRACKET COVER INNER (w/ Center Seat) |
![]() |
Attach the 9 clips to install the seat track bracket cover.
| 4. INSTALL SEAT TRACK BRACKET COVER INNER |
![]() |
Attach the 6 clips to install the seat track bracket cover.
Lift up the seat track adjusting handle to move the seat to the rearmost position.
| 5. INSTALL REAR SEAT TRACK BRACKET COVER INNER |
![]() |
Attach the 2 claws to install the rear seat track bracket cover.
| 6. INSTALL REAR SEAT TRACK BRACKET COVER OUTER |
![]() |
Attach the 2 claws to install the rear seat track bracket cover.
| 7. INSTALL REAR DOOR SCUFF PLATE RH |
![]() |
Attach the 2 claws and 5 clips to install the rear door scuff plate.
Install the 2 bolts.
![]() |
Attach the 6 claws, 5 clips and 2 guides to install the rear door scuff plate.
Install the bolt.
| 8. INSTALL REAR FLOOR STEP NO. 1 COVER |
![]() |
Attach the 2 claws to install the rear floor step No. 1 cover.
| 9. INSTALL REAR FLOOR STEP NO. 2 COVER |
![]() |
Attach the 2 claws to the install the rear floor step No. 2 cover.
| 10. INSTALL REAR SEAT CUSHION HINGE COVER LOWER RH |
![]() |
Attach the 2 clips and 5 claws to install the rear cushion hinge lower cover RH.