HEADLIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL HEADLIGHT ASSEMBLY |
![]() |
Connect the connectors.
Install the headlight with the 2 screws.
Install the bolt.
| 2. INSTALL FRONT END PANEL (w/o Headlight Cleaner System) |
![]() |
Attach the 2 clips to install the front end panel.
![]() |
Install the 2 clips.
| 3. INSTALL FRONT END PANEL (w/ Headlight Cleaner System) |
![]() |
Attach the 2 claws and 2 clips to install the front end panel.
![]() |
Install the 2 clips.
| 4. PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT |
Prepare the vehicle:
| 5. PREPARE FOR HEADLIGHT AIMING (for Using a Tester) |
Prepare the vehicle for headlight aim check.
Adjust in accordance with the headlight tester instructions.
| 6. PREPARE FOR HEADLIGHT AIMING (for Using a Screen) |
![]() |
Prepare the vehicle.
| *a | 90 ° |
| *b | 25 m or 3 m |
Prepare a piece of thick white paper approximately 2 m (6.56 ft.) (height) x 4 m (13.1 ft.) (width) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H, V LH, and V RH lines) on the screen as shown in the illustration.
| *a | V LH Line |
| *b | V Line |
| *c | V RH Line |
| *d | H Line |
| *e | Ground |
H Line (Headlight height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the headlight bulb center marks of the low beam headlights.
V LH Line and V RH Line (Center mark positions of left-hand (LH) and right-hand (RH) headlights):
Draw 2 vertical lines so that they intersect the H line at each center mark (aligned with the center of the low beam headlight bulbs).
| 7. INSPECT HEADLIGHT AIMING |
Cover the headlight or disconnect the connector of the headlight on the opposite side to prevent light from the headlight that is not being inspected from affecting the headlight aiming.
Start the engine.
Turn on the headlight and check if the cutoff line matches the preferred cutoff line in the following illustration.

Turn on the high beams and check if the center of intensity for each high beam matches the center of intensity in the illustration.

| 8. ADJUST HEADLIGHT AIMING |
![]() |
Using a screwdriver, adjust the aim.
Adjust the aim of each headlight to the specified range by turning each aiming screw with a screwdriver.
| *1 | Vertical Aiming Screw |
| *2 | Horizontal Aiming Screw |