REAR SEAT ENTERTAINMENT SYSTEM > Television Display Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-17 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-1 (+B) - Body ground | Always | 11 to 14 V |
| U13-2 (ACC) - Body ground | Ignition switch ACC |
| *a | Front view of wire harness connector (to Television Display Assembly) |
|
| ||||
| OK | ||
| ||