Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Television Display Power Source Circuit

for Preparation Click here


DESCRIPTION

This is power source circuit of the television display assembly.

WIRING DIAGRAM


E138083E03


INSPECTION PROCEDURE

1.INSPECT FUSE (RAD NO. 1, ACC)
  1. Remove the ACC fuse from the cowl side junction block LH.

  1. Remove the RAD NO. 1 fuse from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    RAD NO. 1 fuse
    Always
    Below 1 Ω
    ACC fuse



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND)


    E192430E71
  1. Disconnect the U13 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U13-17 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    U13-1 (+B) - Body ground
    Always
    11 to 14 V
    U13-2 (ACC) - Body ground
    Ignition switch ACC



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)