REAR SEAT ENTERTAINMENT SYSTEM > Television Display Power Source Circuit |

| 1.INSPECT FUSE (RAD NO.1, ACC) |
Remove the ACC fuse from the cowl side junction block LH.
Remove the RAD NO.1 fuse from the engine room junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| RAD NO.1 fuse | Always | Below 1 Ω |
| ACC fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the U13 television display assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-17 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-1 (+B) - Body ground | Always | 11 to 14 V |
| U13-2 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
|
| ||||
| OK | ||
| ||