Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Mute Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

The radio receiver assembly controls the volume according to the mute signal from the television display assembly.

WIRING DIAGRAM


E145845E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - RADIO RECEIVER ASSEMBLY)


    E145843E07
  1. Disconnect the U2 television display assembly connector.

  1. Disconnect the I8 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U2-26 (MUTE) - I8-6 (MUTE)
    Always
    Below 1 Ω
    U2-26 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TELEVISION DISPLAY ASSEMBLY


    E145846E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    U2-26 (MUTE) - Body ground
    Ignition switch ACC, television display is playing → Changing modes
    3.5 V or higher → Below 1 V



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)