REAR SEAT ENTERTAINMENT SYSTEM > Mute Signal Circuit between Radio Receiver and Television Display Assembly |

| 1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - RADIO RECEIVER ASSEMBLY) |
![]() |
Disconnect the U2 television display assembly connector.
Disconnect the I8 radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U2-26 (MUTE) - I8-6 (MUTE) | Always | Below 1 Ω |
| U2-26 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK TELEVISION DISPLAY ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| U2-26 (MUTE) - Body ground | Ignition switch ACC, television display is playing → Changing modes | 3.5 V or higher → Below 1 V |
|
| ||||
| OK | ||
| ||