POWER BACK DOOR WARNING BUZZER > REMOVAL |
| 1. REMOVE POWER BACK DOOR ROD |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and power back door rod.
| 2. REMOVE BACK DOOR CENTER GARNISH |
![]() |
Detach the 4 clips and the claw and remove the back door center garnish.
| 3. REMOVE BACK DOOR SIDE GARNISH RH |
![]() |
Detach the 2 clips and remove the back door side garnish RH.
| 4. REMOVE BACK DOOR SIDE GARNISH LH |
![]() |
Detach the 3 clips and remove the back door side garnish LH
| 5. REMOVE BACK DOOR STRAP COVER |
![]() |
Slide the back door strap cover and detach the claw and remove the back door strap cover.
| 6. REMOVE BACK DOOR PULL STRAP |
![]() |
Remove the bolt and remove the back door pull strap.
| 7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Detach the 11 clips and remove the back door trim board assembly.
| 8. REMOVE POWER BACK DOOR WARNING BUZZER |
![]() |
Disconnect the connector.
Detach the clamp and remove the power back door warning buzzer.