Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR TOUCH SENSOR (for LH Side)

POWER BACK DOOR TOUCH SENSOR (for LH Side) > REMOVAL

for Preparation Click here



1. REMOVE POWER BACK DOOR ROD


    B194506E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and power back door rod.



2. REMOVE BACK DOOR CENTER GARNISH


    B190514
  1. Detach the 4 clips and the claw and remove the back door center garnish.



3. REMOVE BACK DOOR SIDE GARNISH RH


    B190515
  1. Detach the 2 clips and remove the back door side garnish RH.



4. REMOVE BACK DOOR SIDE GARNISH LH


    B190516
  1. Detach the 3 clips and remove the back door side garnish LH



5. REMOVE BACK DOOR STRAP COVER


    B190521
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



6. REMOVE BACK DOOR PULL STRAP


    B190519
  1. Remove the bolt and remove the back door pull strap.



7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B190520
  1. Detach the 11 clips and remove the back door trim board assembly.



8. REMOVE BACK DOOR SERVICE HOLE COVER


    B190521
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



9. REMOVE POWER BACK DOOR SENSOR LH


    B192121
  1. Disconnect the connector.

  1. Remove the 6 screws.

  1. Detach the 2 clips and remove the power back door sensor assembly.