Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG CUTOFF SWITCH

CURTAIN SHIELD AIRBAG CUTOFF SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 SWITCH HOLE BASE


    B192561
  1. Using a moulding remover, detach the 6 claws and remove the No. 1 switch hole base.



3. REMOVE CURTAIN AIRBAG CUTOFF SWITCH


E141183
  1. Disconnect the connector.

  1. Detach the 2 claws and remove the switch.