Home › Vehicle Interior › INTERIOR PANELS / TRIM › FRONT CONSOLE BOX (w/ Cool Box)

FRONT CONSOLE BOX (w/ Cool Box) > INSPECTION

for Preparation Click here



1. INSPECT COOL BOX BLOWER WITH FAN MOTOR SUB-ASSEMBLY


    B188371E03
  1. Apply battery voltage to the blower motor connector and check the operation of the cool box blower with fan motor sub-assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Cool Box Blower with Fan Motor Sub-Assembly)

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor operates smoothly

    If the result is not as specified, replace the cool box blower with fan motor sub-assembly.



2. INSPECT COOLER THERMISTOR


    B185166E02
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Sensor
    *a
    Component without harness connected
    (Cooler Thermistor)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    -10°C (14°F)
    7.40 to 9.20 kΩ
    1 - 2
    -5°C (23°F)
    5.65 to 7.00 kΩ
    1 - 2
    0°C (32°F)
    4.35 to 5.40 kΩ
    1 - 2
    5°C (41°F)
    3.40 to 4.20 kΩ
    1 - 2
    10°C (50°F)
    2.68 to 3.30 kΩ
    1 - 2
    15°C (59°F)
    2.10 to 2.60 kΩ
    1 - 2
    20°C (68°F)
    1.66 to 2.10 kΩ
    1 - 2
    25°C (77°F)
    1.32 to 1.66 kΩ
    1 - 2
    30°C (86°F)
    1.05 to 1.35 kΩ

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    2. When measuring, the sensor temperature must be the same as the ambient temperature.

    HINT:
    1. As the temperature increases, the resistance decreases (see the graph).
    2. If the result is not as specified, replace the cooler thermistor.