Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Rear Air Conditioning Control Panel Circuit

for Preparation Click here


DESCRIPTION

This circuit consists of the air conditioning control assembly and the air conditioning amplifier assembly. When the air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning control assembly is operated.

WIRING DIAGRAM


E157369E19


INSPECTION PROCEDURE

1.INSPECT FUSE (LH-IG)


    E160643E11
  1. Remove the LH-IG fuse from the main body ECU (cowl side junction block LH).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    LH-IG fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)
  1. Disconnect the S4 air conditioning control assembly connector.



    E161572E02
  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S4-4 (E) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S4-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)


    E161573E02
  1. Disconnect the S4 air conditioning control assembly connector.

  1. Disconnect the H67 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H67-13 (RLIN) - S4-5 (RLIN)
    Always
    Below 1 Ω
    S4-5 (RLIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK AIR CONDITIONING CONTROL ASSEMBLY (OPERATION)
  1. Replace the air conditioning control assembly with a new or properly functioning one (Click here).

  1. Operate the air conditioning control assembly to check that it functions properly.

    OK:
    Air conditioning control assembly function operates normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

END (AIR CONDITIONING CONTROL ASSEMBLY IS FAULTY)