Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Air Conditioning Control Panel does not Operate

for Preparation Click here


DESCRIPTION

This circuit consists of the integration control and panel assembly and the air conditioning amplifier assembly. When the integration control and panel assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the integration control and panel assembly is operated.

WIRING DIAGRAM


E157369E18


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG NO. 1)


    E160643E10
  1. Remove the ECU-IG No. 1 fuse from the main body ECU (cowl side junction block LH).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY AND BODY GROUND)


    E161567E02
  1. Disconnect the H45 integration control and panel assembly connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H45-1 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H45-1 (GND) - H45-16 (IG+)
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - INTEGRATION CONTROL AND PANEL)


    E161568E02
  1. Disconnect the H45 integration control and panel assembly connector.

  1. Disconnect the H24 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H45-3 (STX) - H24-37 (LIN1)
    Always
    Below 1 Ω
    H45-3 (STX) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK INTEGRATION CONTROL AND PANEL ASSEMBLY (OPERATION)
  1. Replace the integration control and panel assembly with a new or properly functioning one (Click here).

  1. Operate the integration control and panel assembly to check that it functions properly.

    OK:
    Integration control and panel assembly function operate normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

END (INTEGRATION CONTROL AND PANEL ASSEMBLY IS FAULTY)