Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH

ENGINE HOOD COURTESY SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK ASSEMBLY


    B220936
  1. Install the hood lock assembly with the nut and 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



    B220935
  1. Install a new hood lock nut cap.



2. INSPECT HOOD LOCK ASSEMBLY


  1. Check that the clearance measurements are within the standard ranges.


    B190504E01


    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    4.0 to 7.0 mm
    (0.157 to 0.276 in.)
    B
    -1.5 to 1.5 mm
    (-0.059 to 0.059 in.)



3. ADJUST HOOD LOCK ASSEMBLY


    B192131
  1. Loosen the 4 hood side hinge bolts.

  1. Move the hood to adjust the clearance to within the standard range.

  1. Tighten the 4 hood side hinge bolts after the adjustment.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    B192132
  1. Adjust the height of the hood front end by turning the cushion rubber.

    HINT:
    The cushion rubber can be raised and lowered by turning it.



  1. Adjust the hood lock.



      B220937
    1. Remove the hood lock nut cap.



    2. B220936
    3. Loosen the 2 bolts and nut.



    4. B166030
    5. Adjust the hood lock position so that the striker can enter it smoothly.



    6. B220936
    7. Tighten the 2 bolts and nut after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



4. INSTALL HOOD LOCK CONTROL CABLE COVER


    B223272
  1. Attach the clamp and install the hood lock control cable cover.

  1. Install the screw.

  1. Install the nut.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



    B223275
  1. Install a new hood lock nut cap.