REAR WIPER MOTOR > INSTALLATION |
| 1. INSTALL REAR WIPER MOTOR GROMMET |
![]() |
Apply MP grease to the entire surface of the wiper motor grommet lip.
![]() |
Install the rear wiper motor grommet with the mark directed up.
| 2. INSTALL REAR WIPER MOTOR ASSEMBLY |
![]() |
Install the rear wiper motor with the 3 bolts.
Connect the connector and clamp.
| 3. INSTALL REAR WIPER BLADE ASSEMBLY |
![]() |
Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).
Clean the wiper pivot serrations with a wire brush.
Operate the wiper, and then stop the windshield wiper motor in the automatic stop position.
![]() |
With the rear wiper blade and linear wiper step in the positions shown in the illustration, install the rear wiper blade assembly with the nut.
![]() |
Place the rear wiper blade assembly in the automatic stop position.
| 4. INSTALL REAR WIPER ARM HEAD CAP |
![]() |
Attach the claw to install the rear wiper head cap.
| 5. INSTALL BACK DOOR SERVICE HOLE COVER |
![]() |
Apply butyl tape to the door panel, then install a new back door service hole cover as shown in the illustration.
| 6. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Attach the 11 clips to install the back door trim board assembly.
| 7. INSTALL BACK DOOR PULL STRAP |
![]() |
Install the back door pull strap with the bolt.
| 8. INSTALL BACK DOOR STRAP COVER |
![]() |
Attach the claw to slid the back door strap cover as shown in the illustration, and install it.
| 9. INSTALL BACK DOOR SIDE GARNISH LH |
![]() |
Attach the 3 clips to install the back door side garnish LH.
| 10. INSTALL BACK DOOR SIDE GARNISH RH |
![]() |
Attach the 2 clips to install the back door side garnish RH.
| 11. INSTALL BACK DOOR CENTER GARNISH |
![]() |
Attach the 4 clips and the claw to install the back door center garnish.
| 12. INSTALL POWER BACK DOOR ROD (w/ Power Back Door) |
![]() |
Install the power back door rod with the 2 stop rings.