REAR WIPER MOTOR > REMOVAL |
| 1. REMOVE POWER BACK DOOR ROD (w/ Power Back Door) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and power back door rod.
| 2. REMOVE BACK DOOR CENTER GARNISH |
![]() |
Detach the 4 clips and the claw and remove the back door center garnish.
| 3. REMOVE BACK DOOR SIDE GARNISH RH |
![]() |
Detach the 2 clips and remove the back door side garnish RH.
| 4. REMOVE BACK DOOR SIDE GARNISH LH |
![]() |
Detach the 3 clips and remove the back door side garnish LH
| 5. REMOVE BACK DOOR STRAP COVER |
![]() |
Slide the back door strap cover and detach the claw and remove the back door strap cover.
| 6. REMOVE BACK DOOR PULL STRAP |
![]() |
Remove the bolt and remove the back door pull strap.
| 7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Detach the 11 clips and remove the back door trim board assembly.
| 8. REMOVE BACK DOOR SERVICE HOLE COVER |
![]() |
Remove the back door service hole cover.
| 9. REMOVE REAR WIPER ARM HEAD CAP |
![]() |
Detach the claw and remove the rear wiper arm head cap.
| 10. REMOVE REAR WIPER BLADE ASSEMBLY |
![]() |
Remove the nut and remove the rear wiper blade assembly.
| 11. REMOVE REAR WIPER MOTOR ASSEMBLY |
![]() |
Detach the clamp and disconnect the connector.
Loosen the 3 bolts and remove the rear wiper motor.
| 12. REMOVE REAR WIPER MOTOR GROMMET |
![]() |
Remove the rear wiper motor grommet.