Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE POWER BACK DOOR ROD (w/ Power Back Door)


    B194506E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the 2 stop rings and power back door rod.



2. REMOVE BACK DOOR CENTER GARNISH


    B190514
  1. Detach the 4 clips and the claw and remove the back door center garnish.



3. REMOVE BACK DOOR SIDE GARNISH RH


    B190515
  1. Detach the 2 clips and remove the back door side garnish RH.



4. REMOVE BACK DOOR SIDE GARNISH LH


    B190516
  1. Detach the 3 clips and remove the back door side garnish LH



5. REMOVE BACK DOOR STRAP COVER


    B190517
  1. Slide the back door strap cover and detach the claw and remove the back door strap cover.



6. REMOVE BACK DOOR PULL STRAP


    B190519
  1. Remove the bolt and remove the back door pull strap.



7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B190520
  1. Detach the 11 clips and remove the back door trim board assembly.



8. REMOVE BACK DOOR SERVICE HOLE COVER


    B190521
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



9. REMOVE REAR WIPER ARM HEAD CAP


    E161700
  1. Detach the claw and remove the rear wiper arm head cap.



10. REMOVE REAR WIPER BLADE ASSEMBLY


    E161701
  1. Remove the nut and remove the rear wiper blade assembly.



11. REMOVE REAR WIPER MOTOR ASSEMBLY


    E161698
  1. Detach the clamp and disconnect the connector.

  1. Loosen the 3 bolts and remove the rear wiper motor.

    NOTICE:
    Do not try to remove the bolts since they are integrated with the motor.



12. REMOVE REAR WIPER MOTOR GROMMET


    E161696
  1. Remove the rear wiper motor grommet.