Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR

HEADLIGHT CLEANER MOTOR > INSPECTION

for Preparation Click here



1. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

HINT:
This check should be performed with the windshield washer motor and pump installed to the washer jar.

  1. Fill the washer jar with washer fluid.



    E161686E01
  1. Connect the positive (+) battery lead to terminal 1 of the headlight cleaner motor and pump, and the negative (-) battery lead to terminal 2. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from the washer jar.

    If the result is not as specified, replace the headlight cleaner motor and pump.