Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR

FRONT ACCELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATION SENSOR ASSEMBLY (for LH Side)


C180585
  1. Install the acceleration sensor with the nut.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the acceleration sensor connector.



2. INSTALL ACCELERATION SENSOR ASSEMBLY (for RH Side)


C180586
  1. Install the acceleration sensor with the nut.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the acceleration sensor connector.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B230430
  1. Connect the connector.



    B226741
  1. Attach the 3 claws to install the finish panel.

  1. Install the 3 <D> screws and bolt <A>.



4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B226758
  1. Attach the 2 guides and 4 claws.

  1. Attach the clip to install the under cover.



5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY


    B225998
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 2 claws to install the DLC3.

  1. Install the 4 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B163883
  1. Attach the 2 claws to install the sensor.



    B229064
  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



7. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

  1. Attach the 3 claws to install the hood lock lever



8. INSTALL INSTRUMENT SIDE PANEL LH


    B229058
  1. Attach the 7 claws to install the side panel.



9. INSTALL INSTRUMENT SIDE PANEL RH


    B229198
  1. Attach the 6 claws to install the side panel.



10. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



11. INSTALL COWL SIDE TRIM BOARD RH


    B190152
  1. Attach the 2 clips to install the cowl side trim board.

  1. Install the clip.



12. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



13. INSTALL FRONT DOOR SCUFF PLATE RH


B190151
  1. Attach the 9 claws to install the scuff plate.