Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR

FRONT ACCELERATION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ACCELERATION SENSOR ASSEMBLY


C179517E02
  1. Inspect the acceleration sensor LH.

    1. Connect 3 dry cell batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 3 (SGV) of the acceleration sensor and the negative (-) end of the batteries to terminal 2 (SGND). Then measure the voltage between terminal 1 (SGRR) and terminal 2 (SGND).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Sensor Condition
      Specified Condition
      1 (SGRR) - 2 (SGND)
      Sensor stationary
      Approx. 2.0 to 2.5 V
      Sensor is tilted
      Change between approx. 0.9 to 2.3 V

      NOTICE:
      Do not apply a voltage of 6 V or higher.

      HINT:
      When the acceleration sensor is tilted, it may output a different value.



    C179517E01
  1. Inspect the acceleration sensor RH.

    1. Connect 3 dry cell batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the acceleration sensor and the negative (-) end of the batteries to terminal 2 (SHG). Then measure the voltage between terminal 1 (SGFL) and terminal 2 (SHG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Sensor Condition
      Specified Condition
      1 (SGFL) - 2 (SHG)
      Sensor stationary
      Approx. 2.0 to 2.5 V
      Sensor is tilted
      Change between approx. 0.9 to 2.3 V

      NOTICE:
      Do not apply a voltage of 6 V or higher.

      HINT:
      When the acceleration sensor is tilted, it may output a different value.