Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR

FRONT ACCELERATION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



3. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



4. REMOVE COWL SIDE TRIM BOARD RH


    B190152
  1. Remove the clip.

  1. Detach the 2 clips and remove the cowl side trim board.



5. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



6. REMOVE INSTRUMENT SIDE PANEL RH


    B229197
  1. Using a moulding remover, detach the 6 claws and remove the side panel.



7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Detach the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



9. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



10. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B226758
  1. Detach the clip and 4 claws.

  1. Detach the 2 guides and remove the under cover.



11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


B226741
  1. Remove the bolt <A> and 3 <D> screws.

  1. Detach the 3 claws and remove the finish panel.



    B230430
  1. Disconnect the connector.



12. REMOVE ACCELERATION SENSOR ASSEMBLY (for LH Side)


C180585
  1. Disconnect the acceleration sensor connector.

  1. Remove the nut and acceleration sensor.



13. REMOVE ACCELERATION SENSOR ASSEMBLY (for RH Side)


C180586
  1. Disconnect the acceleration sensor connector.

  1. Remove the nut and acceleration sensor.