Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SWITCH

HEIGHT CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEIGHT CONTROL SWITCH (NO. 1 ABSORBER CONTROL SWITCH)


    C271459E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (LSW) - 6 (E)
    "Down" pressed
    Below 1 Ω
    Not pressed
    10 KΩ or higher
    5 (HSW) - 6 (E)
    "Up" pressed
    Below 1 Ω
    Not pressed
    10 KΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Height Control Switch)
    If the result is not as specified, replace the height control switch (No. 1 absorber control switch).



2. INSPECT HEIGHT CONTROL MODE SELECT SWITCH (NO. 2 ABSORBER CONTROL SWITCH)


    C271458E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 6
    Pressed
    Below 1 Ω
    Not pressed
    10 KΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Height Control Mode Select Switch)
    If the result is not as specified, replace the height control mode select switch (No. 2 absorber control switch).