Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > INSPECTION

for Preparation Click here



1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


C179494E02
  1. Inspect the rear height control sensor sub-assembly LH.

    1. Connect 3 dry cell batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRL) and terminal 1 (SHG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Sensor Condition
      Specified Condition
      2 (SHRL) - 1 (SHG)
      High (45°)
      4.4 to 4.6 V
      Normal (0°)
      2.3 to 2.6 V
      Low (-45°)
      0.4 to 0.6 V

      NOTICE:
      Do not apply a voltage of 6 V or higher.



    C179494E01
  1. Inspect the rear height control sensor sub-assembly RH.

    1. Connect 3 dry cell batteries of 1.5 V in series.

    2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Sensor Condition
      Specified Condition
      2 (SHRR) - 1 (SHG)
      High (45°)
      4.4 to 4.6 V
      Normal (0°)
      2.3 to 2.6 V
      Low (-45°)
      0.4 to 0.6 V

      NOTICE:
      Do not apply a voltage of 6 V or higher.