Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > INSPECTION

for Preparation Click here



1. INSPECT REAR STABILIZER LINK ASSEMBLY LH


C124387
  1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

  1. Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.

    Standard turning torque:
    0.05 to 1.96 N*m (0.51 to 20.0 kgf*cm, 4.51 to 17.3 in.*lbf)

    If the value is not within the specified range, replace the rear stabilizer link with a new one.

  1. Check the dust boot for cracks or grease leakage.