Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE TAILPIPE ASSEMBLY


A204853
  1. Remove the bolt, clamp and gasket.

  1. Disconnect the tailpipe assembly from the 2 exhaust pipe supports.



2. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD)
(Click here)


3. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD)
(Click here)


4. REMOVE REAR STABILIZER LINK ASSEMBLY LH


C180603
  1. Remove the 2 nuts and the rear stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.



5. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



6. REMOVE REAR STABILIZER BRACKET


    C180768E01
  1. Remove the 4 bolts and 2 brackets.



7. REMOVE REAR STABILIZER BAR
  1. Remove the rear stabilizer bar from the vehicle.



8. REMOVE REAR STABILIZER BUSH
  1. Remove the 2 bushes from the rear stabilizer bar.