Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > All Power Windows does not Operate with Door Key Cylinder

for Preparation Click here


DESCRIPTION

When the driver door key cylinder (key linked switch) is turned, the following occurs: 1) the door lock motor receives the signal; 2) the main body ECU sends the signal to the power window regulator motor; and 3) the power window motors are activated.

WIRING DIAGRAM


B220030E01


INSPECTION PROCEDURE

1.CHECK LIN COMMUNICATION SYSTEM
  1. Check for LIN communication system DTCs related to the power window control system.

    OK:
    LIN communication system DTCs are not output.



NG
GO TO LIN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK DTC (B2312)
  1. Check if DTC B2312 is output (Click here).

    OK:
    DTC B2312 is not output.



NG
GO TO DTC (B2312) (Click here)
OK


3.READ VALUE USING INTELLIGENT TESTER (DOOR LOCK SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. According to the display on the intelligent tester, read the "Data List".

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Door Key SW-Lock
    Door key linked lock switch signal / ON or OFF
    ON: Driver side door key cylinder turned to lock position
    OFF: Driver side door key cylinder not turned
    -
    D Door Key SW-UL
    Door key linked unlock switch signal / ON or OFF
    ON: Driver side door key cylinder turned to unlock position
    OFF: Driver side door key cylinder not turned
    -

    OK:
    On the intelligent tester screen, each item changes between ON and OFF according to above chart.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM (Click here)
OK


4.CHECK POWER WINDOW MANUAL FUNCTION
  1. Check that the manual UP/DOWN function using the power window regulator switch can operate the front door power window LH and RH (Click here).



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE MAIN BODY ECU