OIL COOLER > INSTALLATION |
| 1. INSTALL TRANSMISSION OIL COOLER ASSEMBLY |
![]() |
Coat 4 new O-rings with ATF.
Install the 4 O-rings, transmission oil cooler thermostat and transmission oil cooler to the automatic transmission.
Temporarily install the bolt A.
Install the 2 bolts B and tighten them to the specified torque. Then tighten bolt A to the specified torque.
![]() |
Connect the 2 No. 2 transmission oil cooler hoses to the transmission oil thermostat.
| 2. CONNECT WATER BY-PASS PIPE ASSEMBLY |
![]() |
Connect the 2 water by-pass hoses with the 2 clips and install the water by-pass pipe with the bolt.
| 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 3 new nuts.
Connect the air fuel ratio sensor connector.
| 4. ADD ENGINE COOLANT |
Add engine coolant.
![]() |
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Install the reservoir cap.
Press the inlet and outlet radiator hoses several times by hand, and then check the coolant level. If the coolant level is low, add coolant.
Install the radiator cap.
Start the engine and warm it up until the thermostat opens.
Maintain the engine speed at 2000 to 2500 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine, and wait until the engine coolant cools down to ambient temperature.
![]() |
Check that the coolant level is between the FULL and LOW lines.
If the coolant level is below the LOW line, repeat all of the procedures above.
If the coolant level is above the FULL line, drain coolant so that the coolant level is between the FULL and LOW lines.
| 5. ADJUST AUTOMATIC TRANSMISSION FLUID |
Adjust automatic transmission fluid (Click here).
| 6. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK |
| 7. INSPECT FOR ENGINE COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 8. INSPECT FOR EXHAUST GAS LEAK |