OIL COOLER > REMOVAL |
| 1. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.
Tighten the radiator drain cock plug by hand.

| 2. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector and detach the 2 clamps.
![]() |
Remove the 2 bolts from the center exhaust pipe.
Remove the 3 nuts, front exhaust pipe and 2 gaskets.
| 3. DISCONNECT WATER BY-PASS PIPE ASSEMBLY |
![]() |
Remove the bolt and disconnect the 2 water by-pass hoses from the transmission oil cooler. Then separate the by-pass pipe from the automatic transmission.
| 4. REMOVE TRANSMISSION OIL COOLER ASSEMBLY |
![]() |
Disconnect the 2 No. 2 transmission oil cooler hoses from the transmission oil thermostat.
![]() |
Remove the 3 bolts and transmission oil cooler with transmission oil thermostat.
Separate the transmission oil cooler from the transmission oil thermostat.
Remove the 4 O-rings.