DTC B1287 Back Door ECU Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1287 | No communication between the back door ECU and main body ECU for 10 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK DOOR ECU) |
![]() |
Disconnect the H2 main body ECU connector.
Disconnect the V2 back door ECU connector.
Measure the resistance according to the value(s) in the tables below.
| Tester Connection | Condition | Specified Condition |
| H2-10 (LIN2) - V2-16 (MPX1) | Always | Below 1 Ω |
| H2-10 (LIN2) or V2-16 (MPX1) - Body ground | Always | 10 kΩ or higher |
Reconnect the main body ECU connector.
Reconnect the back door ECU connector.
|
| ||||
| OK | |
| 2.CHECK BACK DOOR ECU (BACK DOOR ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the V2 back door ECU connector.
Measure the resistance and voltage according to the value(s) in the tables below.
| Tester Connection | Condition | Specified Condition |
| V2-6 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| V2-1 (BDR) - Body ground | Always | 11 to 14 V |
| V2-7 (BECU) - Body ground |
Reconnect the back door ECU connector.
|
| ||||
| OK | |
| 3.REPLACE BACK DOOR ECU |
Temporarily replace the back door ECU with a new or normally functioning one (Click here).
Clear the DTC (Click here).
| NEXT | |
| 4.CHECK FOR DTC |
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC B1287 is not output | A |
| DTC B1287 is output | B |
|
| ||||
| A | ||
| ||