POWER BACK DOOR TOUCH SENSOR (for RH Side) > INSTALLATION |
| 1. INSTALL POWER BACK DOOR SENSOR RH |
![]() |
Install the power back door sensor with 2 clips.
Install the 6 screws.
Connect the connector.
| 2. INSTALL BACK DOOR NO. 2 SERVICE HOLE COVER |
![]() |
Attach the 2 clips to install the back door No. 2 service hole cover with the 3 screws.
| 3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Attach the 11 clips to install the back door trim board assembly.
| 4. INSTALL BACK DOOR PULL STRAP |
![]() |
Install the back door pull strap with the bolt.
| 5. INSTALL BACK DOOR STRAP COVER |
![]() |
Attach the claw to slid the back door strap cover as shown in the illustration, and install it.
| 6. INSTALL BACK DOOR SIDE GARNISH LH |
![]() |
Attach the 3 clips to install the back door side garnish LH.
| 7. INSTALL BACK DOOR SIDE GARNISH RH |
![]() |
Attach the 2 clips to install the back door side garnish RH.
| 8. INSTALL BACK DOOR CENTER GARNISH |
![]() |
Attach the 4 clips and the claw to install the back door center garnish.
| 9. INSTALL POWER BACK DOOR ROD |
![]() |
Install the power back door rod with the 2 stop rings.