Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT

VANITY LIGHT > INSPECTION

for Preparation Click here




1. INSPECT VISOR ASSEMBLY LH


    E160702E01
  1. Apply battery voltage and check that the vanity light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+)
    → Terminal 2
    Battery negative (-)
    → Terminal 1
    A
    Vanity light comes on
    B to A
    Vanity light gradually becomes brighter
    B
    Vanity light turns off

    If the result is not as specified, replace the visor assembly LH.



2. INSPECT VISOR ASSEMBLY RH


    E160768E01
  1. Apply battery voltage and check that the vanity light comes on.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+)
    → Terminal 2
    Battery negative (-)
    → Terminal 1
    A
    Vanity light comes on
    B to A
    Vanity light gradually becomes brighter
    B
    Vanity light turns off

    If the result is not as specified, replace the visor assembly RH.