Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT

VANITY LIGHT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below are for the LH side.



1. REMOVE VISOR BRACKET COVER RH


    B190134E01
  1. Using a moulding remover B with its tip wrapped in protective tape, detach the 4 claws and remove the visor bracket cover.



2. REMOVE VISOR ASSEMBLY RH


    B190133
  1. Remove the 4 screws and visor.