Home › Vehicle Interior › LIGHTING (INT) › BACK DOOR COURTESY SWITCH

BACK DOOR COURTESY SWITCH > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR CENTER GARNISH


    B190514
  1. Detach the 4 clips and the claw and remove the back door center garnish.



2. REMOVE BACK DOOR SIDE GARNISH RH


    B190515
  1. Detach the 2 clips and remove the back door side garnish RH.



3. REMOVE BACK DOOR SIDE GARNISH LH


    B190516
  1. Detach the 3 clips and remove the back door side garnish LH



4. REMOVE BACK DOOR STRAP COVER


    B190517
  1. Slide the back door strap cover and detach the claw and remove the back door strap cover.



5. REMOVE BACK DOOR PULL STRAP


    B190519
  1. Remove the bolt and remove the back door pull strap.



6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B190520
  1. Detach the 11 clips and remove the back door trim board assembly.



7. REMOVE BACK DOOR SERVICE HOLE COVER


    B190521
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



8. REMOVE BACK DOOR LOCK PROTECTOR SUB-ASSEMBLY


    B223976
  1. Detach the 3 claws and back door lock protector sub-assembly.



9. REMOVE W/MOTOR BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)


    B190532
  1. Disconnect the connector.

  1. Detach the clamp.

  1. Remove the 3 bolts and back door lock.



10. REMOVE W/MOTOR BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)


    B194235
  1. Disconnect the connector.

  1. Detach the clamp.

  1. Remove the 4 bolts and back door lock.