FOG LIGHT ASSEMBLY > INSTALLATION |
| 1. INSTALL FOG LIGHT ASSEMBLY |
![]() |
Attach the 2 claws to install the fog light.
| 2. INSTALL FOG LIGHT MOUNTING BRACKET |
![]() |
Install the fog light mounting bracket with the 3 bolts.
| 3. INSTALL FOG LIGHT COVER |
![]() |
Attach the 4 claws and 2 guides to install the fog light cover.
| 4. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT |
Prepare the vehicle:
| 5. PREPARE FOR FOG LIGHT AIMING |
![]() |
Prepare the following vehicle conditions:
Prepare a piece of thick white paper (approximately 2 m (6.6 ft.) height x 4 m (13.1 ft.) wide) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
Draw two vertical lines so that they intersect the H line at each center mark.
| 6. INSPECT FOG LIGHT AIMING |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light not being inspected from affecting fog light aiming inspection.
Start the engine.
Turn on the fog light and make sure that the cutoff line falls within the specified area, as shown in the illustration.

| 7. ADJUST FOG LIGHT AIMING |
![]() |
Adjust the fog light aim to within the specified range by turning the aiming screw with a screwdriver.