REAR COMBINATION LIGHT ASSEMBLY > ON-VEHICLE INSPECTION |
| 1. CHECK REAR COMBINATION LIGHT ASSEMBLY LH |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O21-2 - O21-1 | Light control switch OFF | Below 1 V |
| Light control switch in TAIL | 11 to 14 V | |
| O21-3 - O21-1 | Brake pedal released | Below 1 V |
| Brake pedal depressed | 11 to 14 V | |
| O23-1 - O23-2 | Turn signal switch OFF | Below 1 V |
| Ignition switch ON and Turn signal switch in LH | 11 to 14 V (60 to 120 times per minute) |
| 2. CHECK REAR COMBINATION LIGHT ASSEMBLY RH |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O20-2 - O20-1 | Light control switch OFF | Below 1 Ω |
| Light control switch in TAIL | 11 to 14 V | |
| O20-3 - O20-1 | Brake pedal released | Below 1 Ω |
| Brake pedal depressed | 11 to 14 V | |
| O22-1 - O22-2 | Turn signal switch OFF | Below 1 Ω |
| Ignition switch ON and turn signal switch in RH | 11 to 14 V (60 to 120 times per minute) |