Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR LIGHT ASSEMBLY


    E161831
  1. Attach the clip and install the rear light.

  1. Install the 2 nuts.

    Torque:
    6.4 N*m{ 65 kgf*cm , 56 in.*lbf }

  1. Connect the connector.



2. INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER


B190525
  1. Attach the 2 clips to install the back door No. 2 service hole cover with the 3 screws.



3. INSTALL BACK DOOR SERVICE HOLE COVER


B190522
  1. Apply butyl tape to the door panel, then install a new back door service hole cover as shown in the illustration.

    HINT:
    1. There should be no wrinkles or folds after attaching the service hole cover.
    2. After attaching the service hole cover, check the quality of the seal.



4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


B190520
  1. Attach the 11 clips to install the back door trim board assembly.



5. INSTALL BACK DOOR PULL STRAP


B190519
  1. Install the back door pull strap with the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



6. INSTALL BACK DOOR STRAP COVER


B195035
  1. Attach the claw to slid the back door strap cover as shown in the illustration, and install it.



7. INSTALL BACK DOOR SIDE GARNISH LH


B190516
  1. Attach the 3 clips to install the back door side garnish LH.



8. INSTALL BACK DOOR SIDE GARNISH RH


B190515
  1. Attach the 2 clips to install the back door side garnish RH.



9. INSTALL BACK DOOR CENTER GARNISH


B190514
  1. Attach the 4 clips and the claw to install the back door center garnish.