Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE BACK DOOR CENTER GARNISH


    B190514
  1. Detach the 4 clips and the claw and remove the back door center garnish.



2. REMOVE BACK DOOR SIDE GARNISH RH


    B190515
  1. Detach the 2 clips and remove the back door side garnish RH.



3. REMOVE BACK DOOR SIDE GARNISH LH


    B190516
  1. Detach the 3 clips and remove the back door side garnish LH



4. REMOVE BACK DOOR STRAP COVER


    B190517
  1. Slide the back door strap cover and detach the claw and remove the back door strap cover.



5. REMOVE BACK DOOR PULL STRAP


    B190519
  1. Remove the bolt and remove the back door pull strap.



6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B190520
  1. Detach the 11 clips and remove the back door trim board assembly.



7. REMOVE BACK DOOR SERVICE HOLE COVER


    B190521
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door.



8. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER (for RH Side)


    B190525
  1. Remove the 3 screws and detach the 2 clips and remove the back door No. 2 service hole cover.



9. REMOVE REAR LIGHT ASSEMBLY


    E161831
  1. Disconnect the connector.

  1. Remove the 2 nuts.

  1. Disengage the clip and remove the rear light.