Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE SPIRAL CABLE SUB-ASSEMBLY
  1. Remove the spiral cable sub-assembly .



2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E183929E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver with its tip wrapped in protective tape, detach the claw and remove the wiper switch.

    NOTICE:
    Do not press the claw too hard, as it may be damaged.



3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    E161844
  1. Disconnect the connector.

  1. Remove the headlight dimmer switch, as shown in the illustration.



    E113832
  1. Detach the 2 claws and remove the headlight dimmer switch.