Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E181678
  1. Attach the 2 claws to install the hazard warning signal switch.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Attach the 12 clips to install the finish panel.

  1. Connect the 2 connectors and clamp.

  1. Attach the 4 claws to install the instrument panel finish panel retainer.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Attach the 2 claws to install the sensor.

  1. Connect the connectors.

  1. Attach the 9 clips and claw to install the finish panel.

  1. Install the 2 <A> bolts.



4. INSTALL INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure for both sides.



5. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



6. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.