Home › Vehicle Exterior › LIGHTING (EXT) › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER RELAY


    E109076E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage not applied
    10 kΩ or higher
    3 - 5
    When battery voltage to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the headlight dimmer relay.



2. INSPECT HEADLIGHT RELAY


    E109076E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage not applied
    10 kΩ or higher
    3 - 5
    When battery voltage to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the headlight relay.



3. INSPECT FOG LIGHT RELAY


    E109078E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage not applied
    10 kΩ or higher
    3 - 5
    Apply battery voltage to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the fog light relay.



4. INSPECT TOWING TAIL RELAY


    E109078E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage not applied
    10 kΩ or higher
    3 - 5
    Apply battery voltage to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the towing tail relay.