Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING

FRONT DOOR BELT MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


B191702
  1. Attach the 5 claws and clip to install a new front door glass outer weatherstrip.



2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


B190501E01
  1. Temporarily install the mirror by inserting the claw on the mirror into the holes on the vehicle.

  1. Tighten the 3 nuts in the sequence shown in the illustration and install the mirror.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



4. INSTALL FRONT ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

HINT:
Use the same procedure as for the RH side .



6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:
Use the same procedure as for the RH side .