Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure described below is for the LH side.



1. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING

HINT:
When removing the rear door window frame rear moulding, heat the vehicle body and rear door window frame rear moulding using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rear Door Window Frame Rear Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or rear door window frame rear moulding excessively.



    B256625E01
  1. Put protective tape around the rear door window frame rear moulding.

  1. Using a moulding remover, detach the 2 clips and remove the double-sided tape to remove the rear door window frame rear moulding.



2. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP


B191703E01
  1. Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip.



    B191704E01
  1. Using a moulding remover, detach the 5 claws and the clip, and remove the rear door glass outer weatherstrip.