Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH

REAR POWER WINDOW SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE REAR DOOR ARMREST BASE UPPER PANEL


    B190574
  1. Detach the 2 clips and 5 claws and remove the rear door armrest base upper panel.



2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B191725E01
  1. Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the rear power window regulator switch.