Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR POWER WINDOW SWITCH

BACK DOOR POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B191732E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      2 - 6
      2 - 7
      UP AUTO
      Below 1 Ω
      2 - 6
      UP
      Below 1 Ω
      2 - 4
      DOWN
      Below 1 Ω
      2 - 3
      2 - 4
      DOWN AUTO
      Below 1 Ω

      If the result is not as specified, replace the back door power window regulator switch.

  1. Check the illumination operation.

    1. Apply battery voltage to the back door power window regulator switch and check that the illumination comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 8
      Battery negative (-) → Terminal 1
      Illumination comes on

      If the result is not as specified, replace the back door power window regulator switch.